Product ID:PAINT HEAT RESISTING ALUMINUM
MSDS Date:07/21/1999
FSC:8010
NIIN:00-857-1938
Status Code:A
MSDS Number: CLKZR

RANDOLPH PRODUCTS CO

701 12TH ST
CARLSTADT, NJ 07072-0830
US

Emergency Phone: 800-255-3924

Info Phone: 201-438-3700

Preparer: BOBBY STOKES

Cage: 77672

RANDOLPH PRODUCTS CO

830 CARLSTADT, NJ 07072-0830 US

Telephone: 201-438-3700

Cage: 77672

ALIPHATIC NAPHTHA

CAS: 8052-41-3

RTECS: WJ8925000

OSHA PEL 2900 MG/M3;500 PPM

ACGIH TLV: 525 MG/M3;100 PPM

PETROLUEM DISTILATE (NAPTHA)

CAS: 64742-89-8

XYLENE

CAS: 1330-20-7

RTECS: ZE2100000

ACGIH TLV: 434 MG/M3;100 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

AROMATIC SOLVENT NAPHTHA

CAS: 64742-95-6

RTECS: WF3400000

Health Hazards Acute and Chronic:PRIMARY ROUTE(S) OF ENTRY: SKIN
CONTACT, SKIN ABSORPTION, EYE CONTACT, INHALATION
Effects of Overexposure:EYE CONTACT: PRIMARY IRRITATION. INHALATION:
HIGH CONCENTRATIONS MAY CAUSE HEADACHES AND DIZZINESS, ARE
ANESTHETIC, AND MAY HAVE OTHER CENTRAL NERVOUS SYSTEM EFFECTS,
INCLUDING DEATH. CONTAINS XYLEN E WHICH HAS SHOWN REPRODUCTIVE
EFFECTS IN MICE. INGESTION: HARMFUL IF SWALLOWED. SKIN CONTACT:
CHRONIC HEALTH EFFECTS ARE POSSIBLE FROM LONG TERM EXPOSURE TO THIS
MATERIAL, INCLUDING DRYING, CRACKIN G AND IRRITATION OF THE SKIN.
REACTS WITH SKIN PROTEIN AND MOISTURE AND CAN CAUSE RASH, SCALING
OR BLISTERING.

First Aid:FIRST AID-SKIN CONTACT: WASH HANDS THOROUGHLY WITH SOAP AND
WATER. FIRST AID-INHALATION: REMOVE TO FRESH AIR, RESTORE
BREATHING. CONSULT A PHYSICIAN. SKIN CONTACT: FLUSH WITH WATER.
EYE CONTACT: F LUSH IMMEDIATELY WITH LARGE AMOUNTS OF WATER.
CONSULT A PHYSICIAN. FIRST AID-INGESTION: DO NOT INDUCE VOMITING.
KEEP PERSON WARM, QUIET AND GET MEDICAL ATTENTION.

Flash Point Method:SCC
Flash Point:=10.C, 50.F
Lower Limits:0.9
Upper Limits:7.0
Extinguishing Media:CO2, DRY CHEMICAL, FOAM, WATER FOG
Fire Fighting Procedures:PROVIDE RESPIRATORY PROTECTION AGAINST FUMES
GENERATED DURING BURNING. WATER STREAM WILL SPREAD FIRE. DO NOT
USE WATER HOSE STREAM. FULL BUNKER GEAR IN FIRE AREA (HELMET WITH
FACE SHIELD, BUNKER CO AT, GLOVES, RUBBER BOOTS)
Unusual Fire/Explosion Hazard:KEEP CONTAINERS SLIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE
WHEN EXPOSED TO EXTREME HEAT. WATER MAY BE USED TO COOL CLOSED
CONTAINERS TO PREVENT PRESSUR E BUILD-UP AND POSSIBLE AUTOIGNITION
OR EXPLOSION WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES AND ANYTHING WHICH COULD CAUSE
FIRE. ELIMINATE SOURCE OF SPILL IF YOU CAN DO SO WITHOUT RISK BY
CLOSING VALVE, PLUGGI NG HOLE, ETC.. APPLY ABSORBENT INERT MATERIAL
(SAND, DUST, VERMICULITE) TO SPILL. CLEAN SPILL WITH BRISTLE
BROOMS. NON-SPARKING TOOLS, CLEAN DRY RAGS. PROTECTIVE CLOTHING
SHOULD BE WORN.

Handling and Storage Precautions:PRE-EXISTING SENSITIVITY TO SOLVENTS
CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS PRODUCT. DRUMS
SHOULD BE GROUNDED WHEN BEING EMPTIED. THE INFO ACCUMULATED HEREIN
IS BELIEVED TO BE ACCURATE BU T IS NOT WARRANTIED TO BE WHETHER
ORIGINATING WITH RANDOLPH PRODUCTS CO, OR NOT.

Respiratory Protection:USE IN A WELL VENTILATED AREA. USE APPROVED
NIOSH RESPIRATORY PROTECTION IF TLV IS EXCEEDED OR OVER EXPOSURE IS
LIKELY. IF EXPOSED TO A HIGH VAPOR CONCENTRATION, LEAVE AREA AT
ONCE.
Ventilation:USE ONLY IN WELL VENTILATED AREA. MECHANICAL (GENERAL)
VENTILATION.
Protective Gloves:NEOPRENE
Eye Protection:SAFETY GLASSES
Other Protective Equipment:RUBBER APRON
Work Hygienic Practices:MFR GAVE NO INFORMATION OF MSDS.
Supplemental Safety and Health
THIS MSDS OBTAINED BY DDRV & ENTERED AT THEIR REQUEST. CONTACT W/MFR
OBTAINED INFORMATION THAT THIS MATERIAL IS USED IN THEIR PLANT TO
ENCAPSULATE THE ITEM & THE MATERIAL IS POLYMERIZED BEFORE LEAVING
THEIR PLANT. IT IS NO LONGER A FLAMMABLE LIQUID AND THE ITEM
QUALIFIES AS AN ARTICLE UNDER OSHA.

Boiling Pt:>244.C, 471.2F
B.P. Text:244-390 F
Vapor Density:IS HEAVIER
VOC Pounds/Gallon:614
VOC Grams/Liter:5.13
Evaporation Rate & Reference:IS LOWER THAN ETHER
Appearance and Odor:THIN SILVER LIQUID. TYPICAL SOLVENT.
Percent Volatiles by Volume:73.5%

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:AVOID STRONG OXIDIZERS, ACIDS AND ALKALIES
Hazardous Decomposition Products:THERMAL DECOMPOSITION RELEASES CARBON
MONOXIDE AND/OR CARBON DIOXIDE.

Waste Disposal Methods:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES AND ANYTHING WHICH COULD CAUSE
FIRE. ELIMINATE SOURCE OF SPILL IF YOU CAN DO SO WITHOUT RISK BY
CLOSING VALVE, PLUGGI NG HOLE, ETC.. APPLY ABSORBENT INERT MATERIAL
(SAND, DUST, VERMICULITE) TO SPILL. CLEAN SPILL WITH BRISTLE
BROOMS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.